Home » Projects

Folded Egg ATCs

4 Comments


To make your folded egg ATCs, you’ll need:

  • A Bunny Club ATC or Peep Show ATC digital sheet, available here at Ten Two Studios in the digital kit section.

  • A printer, and good paper. I printed my sheets on 32lb. laser paper.
  • A glue stick.
  • A ruler or straight edge.
  • Chalk inkpads, if you wish.


Print out the sheet on good paper.

Cut out the interior and exterior backgrounds. Those are the two largest pieces on the sheets.

Glue the interior and exterior backgrounds together, back to back. The interior sheet is shorter, so make sure to start at the straight, short end of the exterior. That will leave a short, shaped section of the exterior uncovered.

When the glue is dry, fold the uncovered exterior section over the interior, creating the bottom flap of the card.

Use a straight edge to measure 3-1/2″ from the bottom, folded edge, and fold the card again, creating a flap that can tuck behind the bottom section.

Cut out the decorative pieces you wish to use, and decorate the inside and outside of the card.

If you wish, edge the card with chalk inks.

Apply a line of glue on the inside of the bottom flap at the fold, and press the flap upward. This will hold the bottom flap in place, and keep the card from poppping open when it’s closed.

4 Comments on “Folded Egg ATCs”

Leave a Comment